Hydro jetting cost (2026)
Short answer
Hydro jetting typically costs about $350 to $600 for a standard visit in 2026, according to Angi, with an average around $475. Jetting a main sewer line often runs about $600 to $1,400. It costs more than snaking because it cleans the whole pipe wall instead of punching a hole through the clog.
In this guide
Hydro jetting clears drains and sewer lines with water at very high pressure, typically 1,500 to 4,000 PSI. A spinning nozzle scours grease, scale, sludge and roots from the pipe walls.
Figures are 2026 national estimates compiled from published cost guides such as Angi, HomeGuide and This Old House. Prices in high-cost metro areas often run above these ranges.
Typical costs
| Job | Typical 2026 cost |
|---|---|
| Single household drain line (kitchen, bath) | About $150 to $300 |
| Standard jetting visit | About $350 to $600 |
| Main sewer line | About $600 to $1,400 |
| Snaking a drain, for comparison | About $150 to $500 |
What affects the price
- Which line. A kitchen branch line is quicker than a 100-foot main line.
- Access. A ground-level cleanout is fastest. Going through a roof vent or pulling a toilet adds time.
- Clog type. Heavy grease or dense tree roots take longer.
- Camera inspection. Often recommended first and sometimes bundled.
- Timing. After-hours and weekend calls cost more.
Hydro jetting vs snaking
Snaking is cheaper and fine for a single, simple clog. Jetting costs more but cleans the pipe back to its full diameter, so it tends to last longer in lines with recurring grease or root problems. For a line that clogs every few months, one jetting can cost less than repeated snaking visits.
Why an inspection should come first
High-pressure water can damage pipes that are already cracked, badly corroded or separated. Before jetting an older clay, cast iron or Orangeburg line, ask for a camera inspection so you know the pipe can take it.
How to compare quotes
- Get at least two or three written quotes for the same scope of work.
- Ask what is included: permits, inspections, cleanup, and any wall, floor or yard restoration.
- Ask about the warranty on both parts and labor.
- Be wary of a quote far below the others and ask what it leaves out.
Common questions
Is hydro jetting safe for old pipes?
It can be too aggressive for pipes that are already cracked or deteriorated. A camera inspection first shows whether the line can handle it.
How often should a sewer line be hydro jetted?
Only as needed. Lines with recurring grease or root problems may benefit every one to two years; most homes never need routine jetting.
Was this article helpful?
Sorry about that. What was missing?
Please do not include personal information. Links are not accepted.
Thanks for your feedback. It helps us improve our guides.
More in Plumbing costs
- Plumbing costs: what drives the price of a repair (start here)
- Water heater element replacement cost
- Water heater anode rod replacement cost (2026)
- Gas line installation cost (2026)
- Water heater expansion tank installation cost (2026)
- Water softener installation cost (2026)
- Well pump replacement cost (2026)
- Sump pump repair cost (2026)
- Water heater maintenance cost: tank and tankless (2026)